Vol. 8 No. 4 (2025): November 2025
Artikel

ANALISA PENGARUH PENAMBAHAN WATER INJECTION SISTEM PADA MOTOR BAKAR 4 LANGKAH TERHADAP KINERJA MESIN

PDF
  • Ferda Hadi Amanda,
  • Joko S Setiyono
Ferda Hadi Amanda
Universitas Pamulang
Joko S Setiyono
Universitas Pamulang

Published 2025-12-05

How to Cite

ANALISA PENGARUH PENAMBAHAN WATER INJECTION SISTEM PADA MOTOR BAKAR 4 LANGKAH TERHADAP KINERJA MESIN. (2025). JOURNAL OF SCIENCE AND SOCIAL RESEARCH, 8(4), 5386-5392. https://doi.org/10.54314/jssr.v8i4.5095

Abstract

 

Abstract: This study aims to analyze the effect of adding a water injection system to a four-stroke internal combustion engine on engine performance, exhaust emissions, and fuel consumption efficiency. The experimental method was conducted by comparing engine conditions before and after the installation of water injection at a water flow rate of 15 ml/s. The results showed that the use of water injection improved engine performance, where torque increased from 14.60 Nm to 15.09 Nm and power from 11.38 hp to 12.07 hp. Furthermore, exhaust emissions were reduced, with CO decreasing from 4.86 ppm/vol to 3.89 ppm/vol and HC from 469 ppm/vol to 209 ppm/vol. These values remain well below the Euro 2 regulation limits (CO 5.5 ppm/vol and HC 2200 ppm/vol), making the system more environmentally friendly. In terms of fuel consumption, water injection significantly improved efficiency, where 1 liter of fuel that previously covered 59 km increased to 73 km, resulting in a 23% efficiency gain. Overall, the application of the water injection system proved to enhance engine performance, reduce emissions, and improve fuel consumption efficiency.

 

Keyword: Water injection, four-stroke engine, engine performance, exhaust emissions, fuel efficiency.

 

Abstrak: Penelitian ini bertujuan untuk menganalisis pengaruh penambahan sistem water injection pada motor bakar 4 langkah terhadap kinerja mesin, emisi gas buang, serta efisiensi konsumsi bahan bakar. Metode pengujian dilakukan dengan membandingkan kondisi mesin sebelum dan sesudah pemasangan water injection pada debit air 15 ml/detik. Hasil penelitian menunjukkan bahwa penggunaan water injection mampu meningkatkan kinerja mesin, di mana torsi awal sebesar 14,60 Nm dan daya 11,38 hp meningkat menjadi 15,09 Nm dan 12,07 hp. Selain itu, terjadi penurunan kadar emisi gas buang, yaitu CO dari 4,86 ppm/vol menjadi 3,89 ppm/vol dan HC dari 469 ppm/vol menjadi 209 ppm/vol. Nilai ini masih berada di bawah ambang batas regulasi Euro 2 (CO 5,5 ppm/vol dan HC 2200 ppm/vol), sehingga lebih ramah lingkungan. Dari sisi konsumsi bahan bakar, water injection memberikan penghematan signifikan, di mana 1 liter bahan bakar yang sebelumnya menempuh jarak 59 km meningkat menjadi 73 km, dengan efisiensi penggunaan sebesar 23%. Secara keseluruhan, penerapan sistem water injection terbukti mampu meningkatkan performa mesin, menurunkan emisi, serta meningkatkan efisiensi konsumsi bahan bakar.

 

Kata kunci: Water injection, motor bakar 4 langkah, kinerja mesin, emisi gas buang, efisiensi bahan bakar.

PDF

Downloads

Download data is not yet available.

References

  1. Ayhan, V. (2020). Investigation of electronic controlled direct water injection for performance and emissions of a diesel engine running on sunflower oil methyl ester. Fuel, 275(April), 117992. https://doi.org/10.1016/j.fuel.2020.117992
  2. Cao, D. N., Hoang, A. T., Luu, H. Q., Bui, V. G., & Tran, T. T. H. (2020). Effects of injection pressure on the NOx and PM emission control of diesel engine: A review under the aspect of PCCI combustion condition. Energy Sources, Part A: Recovery, Utilization and Environmental Effects, 7036. https://doi.org/10.1080/15567036.2020.1754531
  3. Chaniago, I. P., Purwanto, W., Rifdarmon, & Arif, A. (2023). Optimasi Sistem Pengapian Terhadap Emisi Gas Buang Sepeda Motor 4 Langkah Dengan Metode Taguchi. JTPVI: Jurnal Teknologi Dan Pendidikan Vokasi Indonesia, 1(2), 181–190. https://doi.org/10.24036/jtpvi.v1i2.17
  4. Fratita, M., Popescu, F., Martins, J., Brito, F. P., Costa, T., & Ion, I. (2021). Water injection in spark ignition engines—Impact on engine cycle. Energy Reports, 7(May), 374–379. https://doi.org/10.1016/j.egyr.2021.07.113
  5. Golzari, R., Zhao, H., Hall, J., Bassett, M., Williams, J., & Pearson, R. (2021). Impact of intake port injection of water on boosted downsized gasoline direct injection engine combustion, efficiency and emissions. International Journal of Engine Research, 22(1), 295–315. https://doi.org/10.1177/1468087419832791
  6. Kahnooji, M., & Yazdani, K. (2021). The effect of direct water injection on a diesel-gasoline reactivity controlled compression ignition engine. Fuel, 285(April 2020), 119109. https://doi.org/10.1016/j.fuel.2020.119109
  7. Kang, Z., Feng, S., Lv, Y., Wu, J., & Wu, Z. (2021). Effect of direct water injection temperature on combustion process and thermal efficiency within compression ignition internal combustion Rankine engine. Case Studies in Thermal Engineering, 28(October), 101592. https://doi.org/10.1016/j.csite.2021.101592
  8. Marbun, J. (2020). Analisis Sistem Injeksi Air/Metanol Dan Air/Etanol Terhadap Konsumsi Bahan Bakar dan Emisi Gas buang. Jurnal Teknik Mesin ITI, 4(3), 109. https://doi.org/10.31543/jtm.v4i3.518
  9. Noval, M., Studi, P., Teknik, M., Pascasarjana, M., Pasundan, U., Ciamis, B., … Barat, J. (2012). Pengembangan Water Injection System Pada Sepeda. Jurnal Mesin.
  10. Zhuang, Y., Sun, Y., Huang, Y., Teng, Q., He, B., Chen, W., & Qian, Y. (2020). Investigation of water injection benefits on downsized boosted direct injection spark ignition engine. Fuel, 264, 0–20.
  11. https://doi.org/10.1016/j.fuel.2019.11

Most read articles by the same author(s)

1 2 3 4 5 6 7 8 9 10 > >>